How it works

What are QuickLashes?

QuickLashes are DIY under-lash clusters applied with our simple Bond & Seal system for an easy, beginner-friendly application. Worn underneath your natural lashes for a lightweight, seamless finish, they're fully customisable, reusable and can last up to 7 days or more.

Discover QuickLashes

1. BOND

Apply a small amount of bond, at the base of your lashes only.

2. LASH

Apply the QuickLash Cluster up underneath your natural lashes around 1mm away from your waterline.

3. clamp

Clamp your QuickLashes down for a extra strong hold.

4. SEAL

Apply SuperStay along the base of your lashes only to seal them & give them a extra long lasting hold!

QuickLash Application & Removal:

If your QuickLashes aren't lasting as long as you'd hoped, don't worry! It's usually down to application technique rather than the lashes themselves. Here are our top tips for longer-lasting wear:
- Prep your lashes - always apply to clean, dry, oil-free lashes. Any oils or makeup residue can prevent the bond from gripping properly.
- Apply the right amount of Bond - use a thin, even layer at the base of your natural lashes. Too little may reduce hold, while too much can stop the bond from setting properly.
- Position correctly - apply your clusters underneath your natural lashes, around 1–2mm away from your waterline. Applying too close to the waterline can expose the bond to moisture and shorten wear.
- Don't skip SuperStay - we recommend finishing with QuickLash SuperStay to seal the bond, remove any tackiness and maximise wear.
- Clamp securely - wait a few minutes after applying, then gently clamp your natural lashes and the clusters together. Re-clamping each morning, or after showering, can help keep your lashes secure.
- Avoid oil-based products - oil-based cleansers, makeup removers and skincare around the eyes will break down the bond and reduce wear time.
- Be gentle with your lashes - avoid rubbing or touching them throughout the day, as oils and moisture from your hands can weaken the bond.
- After getting them wet QuickLashes are water-resistant, not waterproof. If they get wet, allow them to air dry before gently re-clamping them.
- Keep practising - application gets easier with practice! If you're new to QuickLashes, visit our tutorials and Application 101 guides for tips and techniques to help you achieve the best results.
This is completely normal. QuickLash Bond is designed to stay slightly tacky so your lash clusters can grip securely. We recommend finishing with QuickLash SuperStay to seal the bond, remove any tackiness and maximise wear. If you choose not to use SuperStay, that's perfectly fine just make sure you're applying only a thin layer of Bond, as using too much can leave a tacky finish.
This is usually caused by not enough Bond at the ends, not clamping firmly enough after application, or moisture from watery eyes weakening the bond. Apply a thin, even layer of Bond along the base of your natural lashes, making sure you don't miss the inner and outer corners. Once your lashes are in place, apply SuperStay and clamp well, paying extra attention to the corners.
If one or two clusters lift, there's no need to remove your entire set. Simply remove the lifted cluster, clean away any remaining Bond if needed, and apply a fresh cluster to fill the gap. QuickLashes are designed to be easily topped up whenever needed.
QuickLashes should feel lightweight and comfortable. If they feel uncomfortable, they're likely sitting too close to your waterline. Make sure you apply the clusters approximately 1–2mm below your waterline, rather than directly against the skin.
No. When applied and removed correctly, QuickLashes won't damage your natural lashes. Always apply them around 1–2mm away from your waterline and remove them gently using QuickLash Pro Remover. Avoid pulling the clusters off, as this can put unnecessary stress on your natural lashes.
To remove your QuickLashes safely, always use a QuickLash Remover to dissolve the Bond and prevent damage to your natural lashes. We offer two removers, so you can choose the application method that suits you best - our Oil Based Brush On Remover for precise application or our Pro Remover for quick, easy removal using a cotton pad. Both are specially formulated to remove your QuickLashes gently without causing damage when used correctly.
Absolutely! QuickLashes are designed for everyday wear. As long as you apply and remove them correctly and care for your natural lashes, you can enjoy wearing them as often as you like.

Yes! QuickLashes are reusable when removed carefully. After removal, clean away any remaining Bond, allow the clusters to dry completely, then store them back in their tray ready for your next application.
We don't recommend applying mascara directly to your QuickLashes, as they're designed to be worn for several days. Mascara can be difficult to remove from the lash fibres, making the clusters harder to clean and reuse. For maximum reusability, we recommend avoiding mascara on the lash clusters themselves.
It's completely normal for a little Bond to transfer onto your applicator. Simply wipe the tips with a wipe or oil free solution after each use to keep them clean and prevent clusters from sticking during your next application.
Yes! Once your QuickLashes have fully set, you can shower, swim and go about your normal routine. Although they're water-resistant rather than fully waterproof, they're designed to withstand everyday activities, including swimming.
If your lashes get wet, the most important thing is not to touch or rub them while they're damp, as this can cause the clusters to lift. Instead, allow them to air dry completely, then gently re-clamp them to your natural lashes to help maintain a secure hold.
Yes, but choose an oil-free makeup remover around your eyes. Oil-based removers can break down the bond and shorten the wear of your QuickLashes.
We recommend avoiding oil-based cleansers, makeup removers and skincare around the eye area while wearing QuickLashes. Oils can weaken the bond, causing your lashes to lift sooner than expected. Stick to oil-free products for the best results.